| Gas Safety Panels |
LKGSP4-
The IP54/Sensor 10 heads should be mounted either on a vertical wall or on the ceiling facing downwards,
This is so dust does not settle on the sensor vent.
Electrical connection is made to terminals inside the sensor.
When the rmote sensor or sensors detect the presence of the target gas (Natural, Carbon Monoxide or LP) a signal will be sent back to the panel, the panel then sends a signal to close the gas selenoid valve shutting off the gas supply. The panel will then indicate which zone is in alarm. Once the problem has been rectified the reset button is pressed and the panel should indicate zone on. If there is still gas present in the area (zone) the panel will go into alarm once again.
|
|
|
